anykruto.blogg.se - Fix cve-2017-14491 for mac

#Fix cve 2017 14491 for mac code#
#Fix cve 2017 14491 for mac mac#

CSA generation process would get stuck occasionally.

802.11r changes caused many devices from associating on r25-0 with A11r and 802.11r enabled.

Rare case where radio would become unresponsive and cause AP to reboot (MR16).

DFS channel change occasionally resulted in a AP hang.

Initial stable firmware (MR33/MR30H/MR74).

#Fix cve 2017 14491 for mac mac#

RADIUS MAC based auth for LAN ports on MR30H.APs lose connectivity to dashboard until reboot in certain cases (MR33/74).Condition under investigation causes radios to become unresponsive for 5 seconds in high-density networks (MR34/MR32/MR72/MR26).Bridge Mode Wireless Client isolation prevents access to splash pages.Tuned MCS EVM to improve rate vs range (MR42).Client Steering performance improvements (All MRs).

Outdoor APs in the IC Regulatory Domain to not broadcast channels on frequencies higher than 5.35 GHz (Channel 64).

Erroneous DFS detection on some APs under certain conditions (MR26/32/34/72).

Performance improvements for Distributed 元 roaming (MR42/52/53/84).

APs would lose connectivity dashboard and reboot (MR16/66).

A corner case where APs could be potentially re-flashed upon boot up (All MR’s).

A corner case would cause AP to stop serving clients.

Wireless packet capture missing a number of 802.11 frames (MR42/MR52/MR53/MR84).Mesh peering issue and recovery issue causes mesh instability (MR42/MR52/MR53/MR84).

Condition under investigation causes Outdoor APs in the IC Regulatory Domain to not broadcast channels on frequencies higher than 5.35 GHz (Channel 64).Condition under investigation causes client to end fast roam midway through EAPOL which causes the client connection to hang.Condition under investigation causes MR34/MR32/MR72/MR26 to become unstable and reboot.Condition under investigation causes radios to become unresponsive for 5 seconds in high density networks (MR34/MR32/MR72/MR26).Condition under investigation causes 2.4GHz radios to become unresponsive (MR32/MR72).Condition under investigation causes lower than expected throughput on the 2.4GHz radio (MR26/MR34).Various other security and performance improvements.Some clients and APs were reported with high RSSIs (255dB) which were inaccurate (MR42/MR52/MR53/MR84).Support CoA though Meraki VPN tunnel for VPN SSIDs.Mesh over wire to allow repeater APs in remote area to serve other repeater APs over the wired interface.Additional features for MR30H LAN ports.This is a record on the CVE List, which provides common identifiers for publicly known cybersecurity vulnerabilities.The new firmware includes support for the following features: Necessarily indicate when this vulnerability wasĭiscovered, shared with the affected vendor, publicly The CVE ID was allocated or reserved, and does not MLIST: 20171002 IMPORTANT SECURITY INFORMATION.ĭisclaimer: The record creation date may reflect when.Note: References are provided for the convenience of the reader to help distinguish between vulnerabilities.

#Fix cve 2017 14491 for mac code#

Heap-based buffer overflow in dnsmasq before 2.78 allows remote attackers to cause a denial of service (crash) or execute arbitrary code via a crafted DNS response.